Ram Air Hoods/Hood Scoops Ram Air Hoods Our new generation 'Power Hood' will not only fill your "need for speed" but will also meet your desire for a quality constructed product. Our new generation ram air hoods are made from OEM engineered materials for a perfect fit and finish every time! It will only take you approximately 30 minutes to install a brand new hood. Ram Air Box If you feel the "need for speed," then just add on one of our Ram Air Boxes and high flow filters! Our air boxes are designed to give your vehicle more horse power and fuel efficiency by inducing more cold air into your air intake system. OEM Engineered Materials (High-Impact Plastic) More and more today, OEMs (Original Equipment Manufacturers) are using engineered plastics as the product of choice for body panels on their vehicles. There is a good reason for that. They are lighter in weight, which makes vehicles more fuel-efficient, plastic does not rust and it does not damage easily. Some good examples of engineered plastics are the GM Saturn. It's body panels are comprised mostly of plastic. Most front and rear fascias are plastic as well. Also the front fenders of the 2002 Trans Am are engineered plastic. While our ram air hood is made from a more rigid plastic, it also has great impact and heat resistance. Engineered plastic body panels are made with machines that have aluminum or steel molds, and have perfect repeatability from part to part. Aluminum and steel molds are very reliable. Engineered plastics are the perfect choice because in the long-run, they hold up better, are lighter, easier to paint, have better impact resistance and make for a perfect fit every time. Engineered plastics are not to be confused with urethane plastic parts, which are often used in the aftermarket. Unlike urethane parts (where paint does not adhere well), primer and paint stick very well to engineered plastic. Reinforced Fiberglass Construction Many of our ram air hoods are constructed of high-strength, hand-laid fiberglass composite construction, using high quality "ISO resin" to give you the best possible quality in a fiberglass hood. Features full underside panel for complete, finished appearance. It comes with a smooth gel-coat finish, on both top and underside surfaces for easy preparation and painting. Easily installs to factory hood hinges with no modification required. All hinge and latch mountings are reinforced with steel plates. All bolt holes are pre-drilled and tapped for easy installation. To install these hoods, all you need to do is transfer your stock hardware onto it and bolt it on to the factory hinges for final alignment. ISO resins are a higher quality, low shrink resin that allows the part to withstand more heat and prevent distortion. Radco has been your Truck Accessory Pro since 1976, with locations in Minnesota, North Dakota, and South Dakota. When your Truck looks good, you look good!